How to Install Peel and Stick Wallpaper in a Corner
Transforming a room with peel and stick wallpaper is an easy way to make a dramatic change. It is especially useful for tackling tricky areas like angled corners, baseboards and crown moulding.
Start by marking the precise corner location on the wall. This is where you will cut away the excess corner wallpaper.
Preparation
Before you start hanging your wallpaper, make sure the wall surface is clean and smooth. It can be helpful to use a primer to prepare the wall for the wallpaper and to fill any holes or cracks. Once your primer is dry, you can begin applying the wallpaper.
When you’re installing wallpaper in a corner, it is important to line up the pattern correctly with each strip of wallpaper. You should always start at the top of the wall and work your way down, smoothing as you go. For more info, do visit this website wallpaper singapore.
When you’re working with a tight space, it’s also a good idea to take the time to remove the faceplates from electrical outlets and light switches. This will allow you to cut the wallpaper to fit around these obstructions. Then you can begin applying the wallpaper to the wall and smoothing it down as you go. If you have any air bubbles, pierce them with a needle and smooth them out with a towel or a squeegee.
Hanging the Wallpaper
As with any wallpapering, start by smoothing the top of your wall and removing any bubbles using your smoothing tool. When the first strip is installed, work your way down to the next corner, applying the paste and aligning the pattern as you go.
Some wallpapers may require a little overlapping, depending on how the design is printed; however, some may say to not overlap at all. If you have to overlap, make sure that the edge of the overlapping strip is tucked under the corner piece.
Keep in mind that peel and stick wallpaper will adhere best to clean walls, so be sure that your wall is wiped down before you apply any paste. It’s also a good idea to remove any faceplates on electrical outlets and light switches, if needed. This will allow you to cut the wallpaper to fit around the outlet or switch. Also, be sure to clean and clear the workspace before you begin so that you don’t get slowed down by obstructions.
Trimming the Corners
While it may seem daunting at first, hanging peel and stick wallpaper is actually a relatively easy DIY project. Just remember to take your time and use the right tools for a perfect result every time!
To start, you will need to pre-measure the width of your offcut and mark it high up on the wall. This is your guideline and should be precisely perpendicular to the baseboard/floor and ceiling.
Next, trim the next strip of wallpaper to this measurement and begin hanging it on the wall. As you go, continue to smooth the paper into the corner, using your smoothing tool as needed.
Continue this process with each new strip until you reach the other corner of the room. Once both corners are completed, you can reinstall any faceplates on electrical outlets or light switches in the room. Enjoy your newly transformed space!
Finishing the Job
Peel and stick wallpaper is a great solution when you want a quick upgrade but don’t want to commit to a long-term wallpaper project. It’s also easy to remove when you’re ready for a change. Before you start hanging, it’s a good idea to have a clean wall and to remove any faceplates on the light switches or electrical outlets.
To make the job go more smoothly, it’s a good idea to wear rubber gloves and remove any nail polish before beginning your project. I forgot to do this and ended up with random scratches on my panels (as well as a few holes from where the glue had dried).
Begin by measuring the height of your walls, using the tape measure for accuracy. Then, purchase enough wallpaper to cover the wall plus a little extra for mistakes. Then, carefully cut the first strip. If your pattern is seamless, use the first panel as a guide for how to hang the rest of the strips of wallpaper.